Paper Title :Low Cost surface Plasmon Resonance
Author :Chen-Guang Zhang, Ching-Shu Yen, Shu-Ying Chen, Shwu-Jen Chang, Jen-Tsai Liu, Ching-Jung Chen
Article Citation :Chen-Guang Zhang ,Ching-Shu Yen ,Shu-Ying Chen ,Shwu-Jen Chang ,Jen-Tsai Liu ,Ching-Jung Chen ,
(2015 ) " Low Cost surface Plasmon Resonance " ,
International Journal of Advances in Science, Engineering and Technology(IJASEAT) ,
pp. 5-8,
Special Issue-5,
Abstract : A very low cost surfaceplasm on resonance (LC-SPR)based on 3D printer technology is developed. The system
consists of a detecting unit, a signal processing unit and an own designed software on PC. The detecting part includes a
650nm laser source, a photodiode, two SGSP YAW-100, Au coated sheer glass, a triangular prism, and other components
were printed by a 3D printer. The signal processing unit comprises an analog amplification circuit and an open source
hardware Arduino Mega2560 board as the MCU. The own designed software on PC has been developed to control the whole
system. The total cost of this SPR is less than 10,000 RMB. The performance and stability had been tested by detecting the
resonance angle in air and water. The results showed LC-SPR has high performance and stability.
Keywords - Surface Plasmon Resonance, 3D printer, Arduino.
Type : Research paper
Published : Special Issue-5,
DOIONLINE NO - IJASEAT-IRAJ-DOIONLINE-3594
View Here
Copyright: © Institute of Research and Journals
|
|
| |
|
PDF |
| |
Viewed - 38 |
| |
Published on 2016-01-05 |
|