International Journal of Advances in Science, Engineering and Technology(IJASEAT)
.
current issues
Volume-8,Issue-1  ( Jan, 2020 )
Statistics report
Jun
Submitted Papers : 80
Accepted Papers : 10
Rejected Papers : 70
Acc. Perc : 12%
  Journal Paper

Paper Title
Feasibility Study of using Thermal Simulator to Observe Metallurgical Aspects of Welding Duplex Stainless Steel

Abstract
This study focused on using thermal cycle simulator to investigate the metallurgical modifications that occur during welding of austenitic stainless steel type 304L and duplex stainless steel alloy type 2205. Thermal cycle simulator is known as an effective method to simulate the HAZ in the welded samples. Hence, the temperatures that are applied through this method should not reach the melting temperatures of the welded material. Different peak temperatures, from 500 to 1100oC were applied on the samples. Although the whole heating and cooling process was relatively short and did not exceed7 minutes, both alloys were subject to metallurgical changes such as carbide precipitation in austenitic alloy and ferrite : austenite ratio in duplex alloy. The amount of carbide precipitation increased for longer exposure at specific temperatures. The amount of ferrite contained in duplex alloys increased with increasing peak temperature. However, other phases did not appear noticeably within this period, 7 minutes, at the peak temperatures applied in this study. Keywords - Thermal Cycle Simulation, Chromium Carbide Precipitation, Austenitic Stainless Steel, Duplex Stainless Steel, Ferrite Content.


Author - Fuad Khoshnaw, Veronique Vitry, Fabienne Delaunois

| PDF |
Viewed - 24
| Published on 2020-01-06
   
   
IRAJ Other Journals
IJASEAT updates
Volume-8,Issue-1(Jan, 2020)
The Conference World

JOURNAL SUPPORTED BY